76NetBIOS over IP Client/Server Printing D4Before You Start1. Obtain the Print Driver for your workstation's operating system. Drivers are available on one of theCD-ROMs that came with your Device. They are also typically available for downloading in self-extracting Zip file format from the Internet at www.xerox.com.2. Print a Settings List as stated under the Network Connectivity Tab of this guide.3. On the Settings List, verify that "SMB" is enabled. Also, verify that TCP/IP is enabled as one ofthe supported protocols (NetBEUI may also be displayed). To enable "SMB," if required, follow theprocedure stated under the Microsoft (NetBIOS over IP) item of the NOS Selection menu, accessedfrom the Network Connectivity Tab of this guide.4. The Workstation Print Driver Installation Procedures below ASSUME that you have already Set Upan NT Server to Queue Jobs to the Printer. If you have NOT already set up the NT Server, for aquick-step set up procedure, refer to the instructions supplied under the selection "Microsoft(NetBIOS over IP)," located in the NOS Selection menu, under the Network Connectivity Tab ofthis guide.Windows 95/98/Me Workstation Print Driver InstallationVerify that the Correct Protocols and Services are installed in the workstation1. At the Workstation's Desktop, right-click the Network Neighborhood icon ("My Network Places" inWindows Me) and select Properties.2. On the Configuration Tab, verify that Client for Microsoft Networks is installed. If it is NOT, clickthe Add button, select Client, select Add, select Client for Microsoft Networks, and click OK. If thesetup program fails to find the required files, you will have to click Have Disk… to load the client fromthe Operating System installer disk for this workstation.3. On the Configuration Tab, verify that the TCP/IP protocol is installed. If it is NOT, click the Addbutton, select Protocol, select Add, select TCP/IP Protocol, and click OK. If the setup program failsto find the required files, you will have to click Have Disk… to load the protocol from the OperatingSystem installer disk for this workstation.4. Click the Identification Tab and verify that this workstation has a UNIQUE Computer Name (15characters maximum) and is a member of a workgroup (Workgroup is the default Windows workgroupname).
