55IPP Configuration B14The Internet Printing Protocol provides a convenient way to print over the Internet or Intranet using thedevice's IP address. To support this type of printing, make sure that Port 9100 is enabled at the deviceas stated in the Note at the bottom of the Configure Port 9100 procedure, in the Internet Servicessection of this guide. Specifically, click the Port Status hot link on the Properties Tab of Internet Servicesand make sure that the check box on the Port 9100 line is checked. The Internet Printing Protocol mustalso be enabled at the device, and the Internet Print Service must be available and installed on theindividual desktop workstation's version of Windows. IPP support is already built into Windows 2000 andXP. For other desktop operating systems it is available as a download from Microsoft atwww.microsoft.com. The final step is to install the IPP print driver, which is covered in the Print Driverssection of this guide.To access IPP Settings at the Device1. Press the rectangular Log In / Out button on the Control Panel.2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default"password.")3. Press the rectangular Confirm button on the touch screen.4. Press the System Settings button (the right-hand button of the two buttons displayed on the touchscreen). Note: If you press the left button by mistake, the Main menu will be displayed and you willhave to start over at step one above.5. Press the System Settings button.6. Press the Network Settings button.7. Press the Port Settings button to access the Port Settings menu.8. Press the IPP selection line on the Port Settings menu.9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.10. When the IPP selection menu displays, note that you have two selections available on numberedhorizontal lines. The first selection is Port Status. The second is IPP – Added Port Number. TheClose button in the upper right corner of the screen returns you to the Port Settings menu. Afterpressing the horizontal line selection, to access available settings press the Change Settings buttonin the lower right corner of the touch screen.
