112 www.xilinx.com Spartan-3A/3AN Starter Kit Board User GuideUG334 (v1.0) May 28, 2007Chapter 13: DDR2 SDRAM RUCF Location ConstraintsAddressFigure 13-2 provides the User Constraint File (UCF) constraints for the DDR2 SDRAMaddress pins, including the I/O pin assignment and the I/O standard used.Miscellaneous SD_LOOP_IN H4 I/O self-calibration loop. Direction can bereversed if more convenient in the FPGAapplication.SD_LOOP_OUT H3SD_ODT P1 DDR2 SDRAM on-device termination controlTable 13-1: FPGA-to-DDR2 SDRAM Connections (Continued)CategoryDDR2 SDRAMSignal NameFPGA PinNumber FunctionFigure 13-2: UCF Location Constraints for DDR2 SDRAM Address InputsNET "SD_A<15>" LOC = "W3" | IOSTANDARD = SSTL18_II ;NET "SD_A<14>" LOC = "V4" | IOSTANDARD = SSTL18_II ;NET "SD_A<13>" LOC = "V3" | IOSTANDARD = SSTL18_II ;NET "SD_A<12>" LOC = "Y2" | IOSTANDARD = SSTL18_II ;NET "SD_A<11>" LOC = "V1" | IOSTANDARD = SSTL18_II ;NET "SD_A<10>" LOC = "T3" | IOSTANDARD = SSTL18_II ;NET "SD_A<9>" LOC = "W2" | IOSTANDARD = SSTL18_II ;NET "SD_A<8>" LOC = "W1" | IOSTANDARD = SSTL18_II ;NET "SD_A<7>" LOC = "Y1" | IOSTANDARD = SSTL18_II ;NET "SD_A<6>" LOC = "U1" | IOSTANDARD = SSTL18_II ;NET "SD_A<5>" LOC = "U4" | IOSTANDARD = SSTL18_II ;NET "SD_A<4>" LOC = "U2" | IOSTANDARD = SSTL18_II ;NET "SD_A<3>" LOC = "U3" | IOSTANDARD = SSTL18_II ;NET "SD_A<2>" LOC = "R1" | IOSTANDARD = SSTL18_II ;NET "SD_A<1>" LOC = "T4" | IOSTANDARD = SSTL18_II ;NET "SD_A<0>" LOC = "R2" | IOSTANDARD = SSTL18_II ;