YASKAWA VIPA IM 053EC Manual

Also see for VIPA IM 053EC: Manual

For wires with a core cross-section of 0.08mm2 up to 1.5mm2.Pos. Function Type Description1 --- --- not connected2 DC 24V I DC 24V for power section supply3 0V I GND for power section supply4 Sys DC 24V I DC 24V for electronic section supply5 --- --- not connected6 DC 24V I DC 24V for power section supply7 0V I GND for power section supply8 Sys 0V I GND for electronic section supplyI: InputCAUTION!Since the power section supply is not internally protected, it is to be exter-nally protected with a fuse, which corresponds to the maximum current.This means max. 10A is to be protected by a 10A fuse (fast) respectivelyby a line circuit breaker 10A characteristics Z!The electronic power section supply is internally protected against highervoltage by fuse. The fuse is within the power module. If the fuse releases,its electronic module must be exchanged!n The power section supply is to be externally protected with a fuse, which correspondsto the maximum current. This means max. 10A is to be protected with a 10A fuse(fast) respectively by a line circuit breaker 10A characteristics Z!n It is recommended to externally protect the electronic power supply for head modulesand I/O area with a 2A fuse (fast) respectively by a line circuit breaker 2A characteris-tics Z.n The electronic power supply for the I/O area of the power module 007-1AB10 shouldalso be externally protected with a 1A fuse (fast) respectively by a line circuit breaker1A characteristics Z.After PowerON of the System SLIO the LEDs RUN respectively MF get on so far as thesum current does not exceed 3A. With a sum current greater than 3A the LEDs may notbe activated. Here the power module with the order number 007-1AB10 is to be placedbetween the peripheral modules.PM - Power moduleFusingState of the electronicpower supply via LEDsVIPA System SLIO Basics and mountingWiring > Wiring power modulesHB300 | IM | 053-1EC00 | en | 16-49 23