Yaesu FT dx 1200 Operating Manual

Also see for FT DX 1200: Operation manual Operating manual Operating manual

Page 101FT D X 1200 O PERA T ING M ANUALM eMory ScAn1. Set the transceiver up in the “Memory” mode bypressing the [V/M] button, if necessary.2. Rotate the [RF/SQL] knob so that the backgroundnoise is just silenced.3. Press and hold in the microphone [UP] or [DWN]key for one second to start scanning in the specifieddirection.A dvice : If the scanner halts on an incoming signal, thedecimal point between the “MHz” and “kHz”digits of the frequency display will blink. If the incoming signal disappears, scanning willresume in about five seconds.4. To cancel scanning, press the [PTT] witch.A dvice : During Memory Group operation, only the channelswithin the current Memory Group will be scanned. If the scan has paused on a signal, pressing the mi-crophone [UP] or [DWN] key will cause scanning toresume instantly. If you press the microphone PTT switch duringscanning, the scanner will halt at once. However,pressing the PTT switch during scanning will notcause transmission. You may select the manner in which the scanner re-sumes while it has paused on a signal, using Menuitem “048 MIC SCAN RESUME”. During memoryscanning, the default “ TIME” (5 sec) setting willcause the scanner to resume scanning after fiveseconds. However, you may change this setting toresume only after the carrier has dropped out, if youlike.quick point:If you have no interest in scanning, and wish to prohibitthe microphone [UP]/[DWN] keys from initiating scan-ning, you may disable scanning control from the mi-crophone using Menu item “047 MIC SCAN” (set it to“DISABLE”).vfo anD memorY scanninG[V/M] Button[RF/SQL] Knob