Yaesu FT dx 1200 Operating Manual

Also see for FT DX 1200: Operation manual Operating manual Operating manual

Page 7FT D X 12 00 O PERA T ING M ANUAL[POWER] button[BAND] keys[AM] button[C.S] button [ENT] buttonbefore You beGinreSetting the MicroproceSSorreSetting MeMorieS (only)Use this procedure to reset (clear) the previously storedMemory channels, without affecting any configurationchanges you may have made to the Menu settings.1. Press the front panel [POWER] switch to turn thetransceiver off.2. While holding the [AM] button in, press and holdin the front panel [POWER] switch to turn the trans-ceiver on. Once the transceiver comes on, you mayrelease the buttons.M enu reSettingUse this procedure to restore the Menu settings to theirfactory defaults, without affecting the memories youhave programmed.1. Press the front panel [POWER] switch to turn thetransceiver off.2. While holding the [MENU] button in, press and holdin the front panel [POWER] switch to turn the trans-ceiver on. Once the transceiver comes on, you mayrelease the buttons.Full reSetUse this procedure to restore all Menu and Memory set-tings to their original factory defaults. All Memories willbe cleared by this procedure.1. Press the front panel [POWER] switch to turn thetransceiver off.2. While holding the [FAST] and [LOCK] buttons in,press and hold in the front panel [POWER] switchto turn the transceiver on. Once the transceivercomes on, you may release the buttons.iMportAnt note:When the optional μTuning Kit is connected to theFTDX 1200, disconnect all the cables from the μTuningKit before performing the Full Reset.[LOCK] button[FAST] button[POWER] button [MENU] button[POWER] buttonA djuSting the clockUse the following procedure to adjust the clock shown at the middle right of the TFT display.1. Press and hold the [C.S] button until the clock digitsblink.2. Enter the present time with the number keys ([BAND]keys).3. Press the [ENT] button.