Yaesu FT dx 1200 Operating Manual

Also see for FT DX 1200: Operation manual Operating manual Operating manual

Page 85FT D X 1200 O PERA T ING M ANUALchecking the cw MeMory contentS1. Be sure that Break-in is still turned “Off” by the[BK-IN] button.2. Press the [MONI] button to enable the CW monitor.3. Press the FH-2 [1] ~ [5] key, whichever memoryyou just recorded in. You will hear the results in thesidetone monitor, but no RF energy will be transmit-ted.note:You may adjust the monitor level setting using Menuitem “036 MONITOR LEVEL”.on -the -A ir cw MeSSAge plAybAck1. Press the [BK-IN] button to enable transmission. Ei-ther Full- or Semi-break-in will be engaged, depend-ing on the setting of Menu item “063 CW BK-IN”.2. Press the FH-2 [1] ~ [5] key, depending on whichCW Memory Register message you wish to transmit.The programmed message will be transmitted on theair.note:If you subsequently decide to use the “Text Memory”technique for memory storage, please note that a mes-sage stored using keyer paddle input will not be trans-ferred over when you select “Text Memory technique”on a particular memory register (the Menu Mode Settingis set to “TEXT”).cw convenience featuresconteSt MeMory keyer (uSing the optionAl Fh-2 reMote control keypAd)M eSSAge MeMory progrAMMing (uSing your pAddle)1. Set the operating mode to CW.2. Set the [BK-IN] button to “Off”.3. Turn the internal Electronic Keyer “On”.4. Press the [MEM] key on the FH-2. A blinking “REC”icon will appear in the display.5. Press any of the FH-2 keys numbered [1] through [5]to begin the memory storage process, and the “REC”icon will glow steadily.6. Send the desired message using your keyer paddle.A dvice :If you do not start keying within ten seconds, thememory storage process will be cancelled.7. Press the [MEM] key on the FH-2 once more at theend of your message. Up to 50 characters may bestored in each of the five memories.note:You must exercise care in sending to ensure that thespaces between letters and words are accurately done; ifyour timing is off, the spacing may not come out rightin the stored message. For ease in setting up the keyermemories, we recommend you set Menu item “018 FKEYER TYPE” and/or “020 R KEYER TYPE” to “ACS”(Automatic Character Spacing) while you are program-ming the keyer memories.