Yaesu FTM-10SR Operating Manual

98 FTM-10SR O PERATING M ANUALMENU (“SET ”) M ODESet Mode Item [F34 SPEAKERF34 SPEAKERF34 SPEAKERF34 SPEAKERF34 SPEAKER]Function: Select the Speaker to be used.Available Values: REAR/F+R/FRONT/OFFDefault: FRONTREAR: Outputs the receiving audio from the “SP/LINE-IN” connector (located in thetransceiver’s body).F+R: Outputs the receiving audio from both FRONT speaker (located in the front panel)and “SP/LINE-IN” connector.FRONT: Outputs the receiving audio from the FRONT (located in the front panel) speaker.OFF: Disable the FRONT speaker and “SP/LINE-IN” connector.Set Mode Item [F35 SQL BELLF35 SQL BELLF35 SQL BELLF35 SQL BELLF35 SQL BELL]Function: Selects the number of CTCSS/DCS/EPCS Bell ringer repetitions.Available Values: OFF/1T/3T/5T/8T/CONT (Continuous ringing)Default: OFFSet Mode Item [F36 SQL DCSF36 SQL DCSF36 SQL DCSF36 SQL DCSF36 SQL DCS]Function: Setting of the DCS code.Available Values: 104 standard DCS codesDefault: DCS(023)Set Mode Item [F37 SQL EXPF37 SQL EXPF37 SQL EXPF37 SQL EXPF37 SQL EXP]Function: Enables/Disables split CTCSS/DCS coding.Available Values: OFF/ONDefault: OFFWhen this Set Mode Item is set to “ON”, you will see the following additional parametersafter the “DCS” parameter while configuring Menu Item “F40 SQL TYPE”.DCS ENC: DCS Encode only.TONE DCS: Encodes a CTCSS tone and Decodes a DCS code.DCS TSQL: Encodes a DCS code and Decodes a CTCSS tone.Select the desired operating mode from the selections shown above.Set Mode Item [F38 SQL LEVLF38 SQL LEVLF38 SQL LEVLF38 SQL LEVLF38 SQL LEVL]Function: Set the squelch threshold level.Available Values: SQL OFF/SQL MIN/SQL 01/SQL 02/ SQL 03/ SQL 04/ SQL 05/ SQL06/ SQL MAXDefault: Amateur Bands: SQL 01, AM: SQL 01, FM: SQL 02