Yaesu FTM-10SR Operating Manual

81FTM-10SR O PERATING M ANUALMISCELLANEOUS S ETTINGSCAN D IRECTIONBy default, the VFO frequency will jump to the low band edge of the current band when theVFO frequency reaches the high band edge. You may change the scanner operation so thatthe VFO frequency will change to downward scanning when the VFO frequency reachesthe high band edge.1. Press and hold the [VOL/SEL] key for one second to activate the Menu mode.2. Rotate the DIAL knob to select Menu Item “F31 SCN DRCT”.3. Press the key to enable selection of this Menu Item.4. Rotate the DIAL knob to set the desired scan mode.NORMAL:When the VFO frequency reaches the high band edge of the current band, theVFO frequency will jump to the low band edge of the current band (or viceversa).RETURN: When the VFO frequency reaches the high band edge of the current bandwhile scanning upward, the scanner will reverse direction and scan down-wards. (or vice versa).5. Press the [VOL/SEL] key to save the new setting and exit to normal operation.SCAN S TART D IRECTIONBy default, the scanner initiates scanning upward when activates the scanner by pressingthe top panels’ key. You may change the scan start direction to downward scanning.1. Press and hold the [VOL/SEL] key for one second to activate the Menu mode.2. Rotate the DIAL knob to select Menu Item “F33 SCN STRT”.3. Press the key to enable selection of this Menu Item.4. Rotate the DIAL knob to set the desired direction.UP START: the scanner initiates scanning upward.DWN.TRART: the scanner initiates scanning downward.Press the [VOL/SEL] key to save the new setting and exit to normal operation.