30 FTM-10SR O PERATING M ANUALSMART M ENU F EATURESSCAN FEATURE1. Press the top panel / key to select “SCAN”.2. Press the key to initiate upward scanning.When the scanner encounters a signal strong enough to openthe squelch, the scanner will halt for five seconds, and thenresume scanning.3. To stop the scanner, press the or PTT key.When the key function is set to “SCAN” via the top panel / key, the keymay be used as the scan start/stop command key.If you want to change the direction of the scan while it is underway, rotate the DIALknob one click in the opposite direction (in this case, one click counter-clockwise). Youwill see the scanner reverse direction and scan down in frequency.The decimal point of the frequency display will blink while the Scan is activated.You may select the Scan Resume mode via the Menu Item “F32 SCN MODE”.When you start the scanner in the memory mode, only the memorized memory channelswill be scannedSMART S EARCH TM O PERATIONThe Smart Search feature allows you to load frequencies automatically according to whereactivity is encountered by your radio. When Smart Search is engaged, the transceiver willsearch above and below your current frequency, storing active frequencies as it goes (with-out stopping on them even momentarily). These frequencies are stored into a special SmartSearch memory bank, consisting of 31 memories (15 above the current frequency, 15 be-low the current frequency, plus the current frequency itself). All channels where activity ispresent will be loaded into the Smart Search memories. The search will stop after onesweep in each direction, whether or not all 31 memories are filled.Storing Smart Search Memories1. Set the radio to the VFO mode. Be sure that you have the Squelch adjusted properly (sothat band noise is quieted).2. Press the top panel / key to select “SSCH”.3. Press the key to initiate upward scanning.4. As active channels are detected, they will automatically bestored into the Smart Search memory bank without causing the sweep to halt.If you want to change direction of the Smart Search while it is underway, rotate theDIAL knob one click in the opposite direction (in this case, one click counter-clock-wise). You will see the scanner reverse direction and Smart Search down in frequency.5. The Smart Search scan will eventually terminate, and the LCD will revert to SmartSearch Memory Channel “”.