Operation52F4B, F5A, F6CEMU42831Adjusting trim angle for manual tiltmodelsWARNINGEWM00401 Stop the engine before adjusting thetrim angle. Use care to avoid being pinched whenremoving or installing the rod. Use caution when trying a trim positionfor the first time. Increase speed gradu-ally and watch for any signs of instabilityor control problems. Improper trim an-gle can cause loss of control.There are 4 or 5 holes provided in the clampbracket to adjust the outboard motor trim an-gle.1. Stop the engine.2. Tilt the outboard motor up, and then re-move the trim rod from the clamp brack-et.F2.5AF4B, F5A, F6C3. Change the position of the trim rod in di-rection “A” to raise the bow (“trim-out”).Change the position of the trim rod in di-rection “B” to lower the bow (“trim-in”).TIP:The outboard motor trim angle changes ap-proximately 4 degrees when the trim rod po-sition is changed by 1 hole.4. Make test runs with the outboard motorset at different trim angles to find the po-sition that works best for your boat andoperating conditions.1. Trim operating angleZMU0675411. Trim rod1. Trim rodAB1ZMU07372ZMU067551AB
