Maintenance6712. If “Fogging Oil” is not available, run theengine at engine idle speed until the fuelsystem empties and the engine stops.Check that the engine has stopped, andthen remove the spark plug. Pour a tea-spoonful of clean engine oil into the cyl-inder. Crank several times manually.Install the spark plug.13. Turn off the water supply to the outboardmotor, and then remove the water flushplug and tape.14. Drain the cooling water completely out ofthe outboard motor. Clean the bodythoroughly. Install the fogging hole capand top cowling.15. Install the propeller. For further informa-tion, see page 79.EMU39281Lubrication1. Install the spark plug and torque to prop-er specification. For information on sparkplug installation, see page 73.2. Change the gear oil. For instructions, seepage 80. Inspect the oil for the presenceof water that indicates a leaky seal. Sealreplacement should be performed by anauthorized Yamaha dealer prior to use.3. Grease all grease fittings. For further de-tails, see page 71.TIP:For long-term storage, fogging the enginewith oil is recommended. Contact yourYamaha dealer for information about foggingoil and procedures for your engine.EMU44341Cleaning the outboard motorWhen cleaning the outboard motor, the topcowling must be installed.1. Wash the exterior of the outboard motorusing fresh water. NOTICE: Do notspray water into the air intake. [ECM01841]2. Drain the cooling water completely out ofthe outboard motor. Clean the bodythoroughly.EMU28462Checking painted surface of outboardmotorCheck the outboard motor for scratches,nicks, or flaking paint. Areas with damagedpaint are more likely to corrode. If necessary,clean and paint the areas. A touch-up paint isavailable from your Yamaha dealer.EMU37075Periodic maintenanceWARNINGEWM01982These procedures require mechanicalskills, tools, and supplies. If you do nothave the proper skills, tools, or supplies toZMU068231. Air intake1ZMU07862