62Y3A11 2-3012345678ILower unit (T50/FT50B, FT50C)Check screw — 7 0.7 5.1Lower unit bolt M10 40 4.0 29Drain screw — 7 0.7 5.1Propeller nut — 35 3.5 25Ring nut — 105 10.5 76Water inlet cover screw — 5 0.5 3.6Pinion nut M22 95 9.5 69Bracket unitTiller handle assembly nut (F50/F50A) — 37 3.7 27Engine shut-off switch nut (F50/F50A) — 4 0.4 2.9Tiller handle bracket nut (F50/F50A) — 38 3.8 27Main switch nut (F50/F50A) — 5 0.5 3.7Friction wing nut (FT50C) — 13 1.3 9.4Tiller handle assembly nut (FT50C) — 37 3.7 27Throttle cable (short) locknut (FT50C) — 37 3.7 27Upper mount nut — 24 2.4 17Lower mount nut — 42 4.2 30Trim sensor screw M6 2 0.2 1.4Clamp bracket self-locking nut — 23 2.3 17Power trim and tiltTilt cylinder end screw — 90 9.0 65PTT motor bolt M5 4 0.4 2.9Reservoir cap — 6.5 0.65 4.7Trim cylinder end screw — 80 8.0 58Tilt piston bolt M12 61 6.1 44Relief valve bracket bolt M5 5.3 0.53 3.8Gear pump assembly bolt M6 6.5 0.65 4.7Gear pump bracket bolt M5 5.3 0.53 3.8Electrical unitPulser coil screw — 4 0.4 2.9Starter motor nut — 9 0.9 6.5Part to be tightened Thread size Tightening torquesN·m kgf·m ft·lbTightening torques
