CHKADJ Periodic checks and adjustments3-17 62Y3A113. Remove the reservoir cap 3, and thencheck the fluid level in the reservoir.NOTE:The fluid level should be at the brim of thefiller hole.4. If necessary, add sufficient fluid of therecommended type to the correct level.5. Install the reservoir cap, and then tightenit to the specified torque.6. Install the tilt pin to its original position.Lower unit 3Checking the gear oil level1. Fully tilt the outboard down.2. Remove the check screw 1, and thencheck the gear oil level in the lower case.NOTE:The gear oil level should be at the brim of thecheck hole.3. If necessary, add sufficient gear oil of therecommended type to the correct level.4. Install the check screw, and then tightenit to the specified torque.Replacing the gear oil1. Fully tilt the outboard up, and then sup-port it with the tilt stop lever 1.2. Remove the tilt pin 2, and then install itin the upper tilt pin hole a.3. Release the tilt stop lever and tilt the out-board down until it contacts the tilt pin.Recommended power trim and tilt fluid:ATF Dexron IIReservoir cap: 8 N·m (0.8 kgf·m, 5.8 ft·lb)S62Y35201Recommended gear oil:GEAR CASE LUBE (USA) or Hypoidgear oilSAE: 90Check screw: 7 N·m (0.7 kgf·m, 5.1 ft·lb)
