Yealink VC110 Administrator's Manual

Also see for VC110: Getting started Recovery guide Quick start guide User guide User guide

Contents

Configuring Network61The display device prompts ―Reboot now?‖.6. Select OK to reboot the endpoint immediately.If DHCP is disabled or the endpoint cannot obtain network settings from the DHCPserver, you need to configure them manually.The following parameters should be configured for endpoints to establish networkconnectivity: IP Address: Configure the endpoint to use the assigned IP address. Subnet Mask: Enter the subnet mask address when the endpoint does notautomatically obtain the subnet mask. Gateway: A gateway is a network point that works as an entrance to anothernetwork. Primary DNS /Secondary DNS: Domain Name System (DNS) servers translatesdomain names (for example: www.example.com), which can be easily memorizedby humans, to the numerical IP addresses (192.168.1.15) needed for the purpose ofcomputer services and devices worldwide.Network parameters need to be configured manually on the endpoint are describedbelow.Parameter Description Configuration MethodMode (IPv4/IPv6)Configures the IP address mode.Default: IPv4Note: If you change thisparameter, the IP phone willreboot to make the change takeeffect.Remote ControlWeb User InterfaceStatic IPEnables or disables the endpointto use manually configurednetwork settings.Default: DisabledNote: If you change thisparameter, the endpoint willreboot to make the change takeeffect.Web User InterfaceIP AddressConfigures the IP addressassigned to the endpoint.Default: BlankNote: If you change thisRemote ControlWeb User Interface