ADTRAN TRACER 6000 SERIES manuals
TRACER 6000 SERIES
Table of contents
- Table Of Contents
- Table Of Contents
- System Overview
- Available Interface Modules
- Section 2 Microwave Path Engineering Basics
- calculating the fade margin
- receiver power
- antenna gain
- path distance (d)
- receiver sensitivity
- antenna information
- antenna beam patterns
- other considerations
- Section 3 Engineering Guidelines
- equipment dimensions
- front panel leds
- aux rs232 interface (rj)
- craft port (db)
- mgmt 10/100baset/tx connection (rj-48c)
- dc power connection (plug-in terminal block)
- network module interfaces
- at-a-glance specifications
- Section 4 Network Turnup Procedure
- tools required
- customer provides
- channel selection
- grounding instructions
- supplying power to the unit
- installing modules
- connecting the module interfaces
- Section 5 User Interface Guide
- the TRACER 64x0
- Section 6 Detail Level Procedures
- DLP-2 Logging into the TRACER 64x0
- DLP-3 Setting IP Parameters for the TRACER 64x0
- DLP-4 Verifying Communications Over an IP LAN
- DLP-5 Updating the Firmware Using TFTP
- DLP-6 Updating the Firmware Using XMODEM
- Section 7 MIBs
- Section 8 Troubleshooting Guide
- led indicators
- rf low led
- e1 interface alarms
- system alarms
- step-by-step troubleshooting
- installing/configuring t1 hardware
TRACER 6000 SERIES
Table of contents
- Table Of Contents
- Table Of Contents
- System Overview
- Operational
- Section 2 Microwave Path Engineering Basics
- calculating the fade margin
- receiver power
- antenna gain
- path distance (d)
- receiver sensitivity
- tracer rssi test points
- other considerations
- Section 3 Engineering Guidelines
- equipment dimensions
- front panel leds
- craft port (db)
- reviewing the tracer 6200 rear panel design
- mgmt 10/100baset/tx connection (rj)
- to odu interface (n-type connector)
- to idu
- xt1 module
- at-a-glance specifications
- Section 4 Network Turnup Procedure
- tools required
- customer provides
- quad ethernet switch module
- supplying power to the unit
- mounting options
- outdoor unit (odu)
- installing modules
- instructions for installing network modules
- Section 5 User Interface Guide
- menu descriptions
- Section 6 Detail Level Procedures
- DLP-2 Logging into the TRACER System
- DLP-3 Setting IP Parameters for the TRACER System
- DLP-4 Verifying Communications Over an IP LAN
- DLP-5 Updating the Firmware Using TFTP
- DLP-6 Updating the Firmware Using XMODEM
- Section 7 MIBs
- Section 8 Troubleshooting Guide
- led indicators
- rf low led
- e1 interface alarms
- lan leds
- step-by-step troubleshooting
- installing/configuring t1 hardware
- installing/configuring e1 hardware
manualsdatabase
Your AI-powered manual search engine