10 UPGRADING O PERATIONALSOFTWARE FOR THEOFFICE CONNECT REMOTE 840Introduction This chapter details the updating of the OfficeConnect Remote 840software. It is divided into the following sections: “Obtaining Updated OfficeConnect Remote 840 Software” “Installing Operational Software to the OfficeConnect Remote 840Unit”Obtaining UpdatedOfficeConnectRemote 840SoftwareThe OfficeConnect Remote 840 operational software is stored in theunit's FLASH memory. In order to update the operational software, youmust first obtain and copy it to your PC's hard drive. You can then installit into FLASH memory on the OfficeConnect Remote 840.The method of obtaining the latest versions of the OfficeConnect Remote840 Operational Software is either via the 3Com website,www.3com.com/ocr840 or via the CD. Install the latest versionsoftware from the website or the OfficeConnect Remote 840 CD. Typeshow system, using the CLI interface, to verify the version softwareinstalled on your OfficeConnect Remote 840.If you have erased the operational software from your OfficeConnectRemote 840, you will need to reinstall the software using a utility on yourCD. Follow the procedure described in “Installing Software via DOS”.Once you obtain the OfficeConnect Remote 840 operational software,there are two methods of installing the software into the FLASH memory. OfficeConnect Remote 840 Manager Software Update (preferredmethod). DOS Update.840ug.book Page 1 Friday, July 7, 2000 2:23 PM
