Using the Configuration Audit E-135 5 Press the Save Configuration button on the sidebar to save thesettings you just entered.Step 5: Configuring aLocal IPX NetworkIf you are setting up the OfficeConnect Remote 840 to route IPX, followthese steps.1 From the OfficeConnect Remote 840 home page, select Configuration> Local Site (LAN) > IPX > Add.2 Enter a name for the network, the IPX address of the network, and theframe type of the network running on the LAN.3 Check the Enable IPX box.4 Click the Add button to add this defined IPX network.5 Press the Save Configuration button on the sidebar to save the settingsyou just entered.Step 6: Configuring aLocal Bridge NetworkIf you are setting up the OfficeConnect Remote 840 to bridge traffic,follow these steps:1 From the OfficeConnect Remote 840 home page, select Configuration> Local Site (LAN) > Bridge > Add.2 Enter a name for the network and check the Enable Bridging box.3 Click Add to add this defined bridge network.If you plan to bridge IP packets instead of routing them, you need todisable IP Forwarding. To do this:1 From the OfficeConnect Remote 840 Manager home page, select Global> IP > IP Settings.2 Uncheck the IP Forwarding checkbox, and press the Submit button. Atthis point, you will momentarily lose connectivity.3 To re-establish the connection, press the Stop button on the Webbrowser, and then press the Reload button.Using theConfigurationAuditWhen you have finished the basic configuration, run the ConfigurationAudit by visiting the OfficeConnect Remote 840 home page. Select Tools> Configuration Audit.840ug.book Page 13 Friday, July 7, 2000 2:23 PM
