Managing a Remote Site Profile 3-34 Click Add. Then click Save Configuration on the sidebar topermanently save the changes.The Network Service (PPP and RFC 1483/ RFC 1490), ATM, and networkprotocol (Bridging, IP, and IPX) information has not been configured yet.To make a connection with the remote site you must configure theNetwork Service, ATM, and at least one network protocol. (See“Configuring Network Service Information (PPP / RFC 1483 / RFC 1490)”,“Configuring ATM Information”, and “Configuring Protocol Parameters”for details.)Modifying a RemoteSite Profile1 From the OfficeConnect Remote 840 home page, select Configuration> Remote Site (WAN).2 Select the name of a remote site profile and click Modify. This brings upthe Remote Site General Modify screen.3 Change configuration parameters as needed and use the Next button tocontinue to the ATM, IP, IP Advanced, and IPX configuration screens.For quick help on specific parameters, click the Help button located atthe bottom of each screen.For more detailed help, go to the appropriate place in this guide (see“Configuring ATM Information” and Configuring Other WANParameters). Click Modify on any screen to set all the Remote Site parameters. Click Save Configuration on the sidebar to permanently save thechanges.Deleting a RemoteSite Profile1 From the OfficeConnect Remote 840 home page, select Configuration> Remote Site (WAN).2 Select the name of a remote site profile and click Delete. This brings upthe Remote Site General Delete screen.3 To delete the profile, click Delete. To return to the remote site profileselection list, click Prev.840ug.book Page 3 Friday, July 7, 2000 2:23 PM
