Configuring IP for the LAN 4-3For routing to take place across the OfficeConnect Remote 840, you alsohave to set up a corresponding network over the WAN port (see“Configuring IP for the Remote Site Connection”).Use the Configuration > Local Site (LAN) > IP screen to define ormodify all IP networks over the LAN. Note that all IP networks definedover the LAN only support Ethernet II framing.Adding a Local IPNetworkYou may add multiple IP networks over the Ethernet interface byfollowing these steps:Select Configuration > Local Site (LAN) > IP.Click Add. This brings up a screen containing the following fields:Enter the following information: Name — The name is limited to 32 characters. If you use any blankspaces, surround the whole phrase with double quotes (e.g., “test sitex”). LAN Address — Enter the address of the IP network in this format:ddd.ddd.ddd.ddd where ddd is a value between 1--255. LAN Mask — Enter the mask of the IP network in this format:ddd.ddd.ddd.ddd where ddd is a value between 0--255.By default, RIP is not enabled for this new IP network. If you wish toenable RIP, proceed to the Modify portion of the following section.Click Add when you have entered these fields. This returns to the IPmenu screen.840ug.book Page 3 Friday, July 7, 2000 2:23 PM
