23-7z The filter-policy import command filters the RIP routes received from neighbors, and the routesbeing filtered out will neither be added to the routing table nor be advertised to any neighbors.z The filter-policy export command filters all the routes to be advertised, including the routesredistributed with the import-route command and routes learned from neighbors.z You can also use the filter-policy export command to filter outgoing routes redistributed from aspecified routing protocol.Setting RIP preferenceFollow these steps to set RIP preference:To do... Use the command... RemarksEnter system view system-view —Enter RIP view rip —Set the RIP preference preference value Required100 by defaultEnabling load sharing among RIP interfacesFollow these steps to enable load sharing among RIP interfaces:To do... Use the command... RemarksEnter system view system-view —Enter RIP view rip —Enable load sharing amongRIP interfacestraffic-share-across-interfaceRequiredDisabled by defaultConfiguring RIP to redistribute routes from another protocolFollow these steps to configure RIP to import routes from another protocol:To do... Use the command... RemarksEnter system view system-view —Enter RIP view rip —Configure a default cost foran incoming route default cost value Optional1 by defaultConfigure RIP toredistribute routes fromanother protocolimport-route protocol [ costvalue | route-policyroute-policy-name ]*RequiredBy default, RIP does not redistributeany route from other protocols.
