To do… Use the command… RemarksEnter system view system-view —Mark the priorities for the | outbound } acl-rule { { dscppackets belonging to a VLANtraffic-priority vlan vlan-id { inbounddscp-value | ip-precedence {pre-value | from-cos } } | cos{ pre-value | from-ipprec } |RequiredRefer to the commandmanual for informationabout the acl-ruleand matching specific ACLruleslocal-precedence pre-value }* argument.Configuration example.1.1/24 network segment.ce as 56 for the packets from the 10.1.1.1/24 network segment.1) Method I[Sysname] acl number 2000[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255[Sysname-acl-basic-2000] quit[ Et[Sysname-Ethernet1/0/1] traffic-priority inbound ip-group 2000 dscp 562) Method II system-view[ mber 2[ acl-basic-200 0[Sysname-acl-basic-2000] quit[Sysname] traffic-priority vlan 2 inbound ip-group 200Configuring Traffic Policingtion Traffic Policingz Ethernet 1/0/1 belongs to VLAN 2 and is connected to the 10.1z Mark the DSCP preceden system-viewSysname] interface hernet1/0/1Sysname] acl nuSysname-0000] rule permit source 10.1.1.0 .0.0.2550 dscp 56Refer to sec for information about traffic policing.Cz d. Refer to the ACL module of thismanual for information about defining ACL rules.z The rate limit for traffic policing, and the actions for the packets exceeding the rate limit have beenC ionfiguration prerequisitesThe ACL rules used for traffic classification have been definedetermined.z The ports that need this configuration have been determined.onf guration procedureFollow these steps to configure traffic policing:RemarksTo do… Use the command…Enter system view system-view —Enter Ethernet port interview interface-number —face interface-type45-17