SourceT , such as the source IP address of the log sender. Thisf is the log host.CoTInformation Center ConfigurationInformCom r:his field indicates the source of the informationield is optional and is displayed only when the output destinationntexthis field provides the content of the system information.ation Center Configuration Task Listplete the following tasks to configure information centeTask RemarksConfiguring Synchronous Information Output OptionalConfiguring to Display the Time Stamp with the UTC Time Zone OptionalSetting to Output System Information to the Console OptionalSetting to Output System Information to a Monitor Terminal OptionalSetting to Output System Information to a Log Host OptionalSetting to Output System Information to the Trap Buffer OptionalSetting to Output System Information to the Log Buffer OptionalSetting to Output System Information to the SNMP NMS OptionalConfig ous Inform tS on output re system log, trap, ordebugging information is output when the user is inputting commands, the command line prompt (inommand editing mode a prompt, or a [Y/N] string in interaction mode) and the input information arer the output.This featur is used in the case that your input is interrupted by a large amount of system output. WiththiswheFoll steps to configure synchronous information output:uring Synchron ation Outpuynchronous informati fers to the feature that if the information such ascechoed afteefeature enabled, the system echoes your previous input and you can continue your operations fromre you were stopped.ow theseTo do… Use the command… RemarksEn -view —ter system view systemEnable synchronousinformation output info-center synchronous RequiredDisabled by default59-7
