z You can configure the password aging time when password aging is not yet enabled, but theseconfigured parameters will not take effect.z After the user changes the password successfully, the switch saves the old password in a readablefile in the flash memory.z The switch does not provide the alert function for FTP passwords. And when an FTP user logs inwith a wrong password, the system just informs the user of the password error, and it does notallow the user to change the password.Configuring the Limitation of Minimum Password LengthThis function is used to enable the switch to check the password length when a password is configured.If the switch finds the length of the input password does not meet the limitation, it informs the user ofthis case and requires the user to input a new password.Table 70-3 Configure the limitation of the minimum password lengthOperation Command DescriptionEnter system view system-view —Enable the limitation ofminimum password length password-control length enableOptionalBy default, the limitation ofminimum password length isenabled.Configure the minimumpassword length globally password-control length lengthOptionalBy default, the minimumlength is 10 characters.Configure the minimumpassword length for a superpasswordpassword-control super lengthmin-lengthOptionalBy default, the minimumlength is 10 characters.Create a local user or enterlocal user view local-user user-name —Configure the minimumpassword length for thelocal userpassword-control length lengthOptionalBy default, the minimumlength is 10 characters.