z NDP and NTDP have been enabled on the management device and member devices, and NDP-and NTDP-related parameters have been configured.z A cluster is established, and you can manage the member devices through the managementdevice.2) Configuration procedurePerform the following operations on the management device to synchronize SNMP configurations:To do… Use the command… RemarksEnter system view system-view —Enter cluster view cluster —Create a public SNMPcommunity for the clustercluster-snmp-agentcommunity { read | write }community-name [ mib-viewview-name ]RequiredNot configured by default.Create a public SNMPv3 groupfor the clustercluster-snmp-agent group v3group-name [ authentication |privacy ] [ read-viewread-view ] [ write-viewwrite-view ] [ notify-viewnotify-view ]RequiredNot configured by default.Add a public SNMPv3 user tothe groupcluster-snmp-agentusm-user v3 usernamegroupname[ authentication-mode { md5 |sha } authpassstring[ privacy-mode { des56privpassstring } ] ]RequiredNot configured by default.Create or update the public MIBview information for the clustercluster-snmp-agent mib-viewincluded view-name oid-treeRequiredNot configured by default.z Perform the above operations on the management device of the cluster.z Configuring the public SNMP information is equal to executing these configurations on both themanagement device and the member devices (refer to the SNMP-RMON Operation part in thismanual), and these configurations will be saved to the configuration files of the managementdevice and the member devices.z The public SNMP configurations cannot be synchronized to the devices that are on the clusterblacklist.z If a member device leaves the cluster, the public SNMP configurations will not be removed.3) Configuration example# Configure the public SNMP information for the cluster on the management device, including thefollowing:z The read community name is read_az The write community name is write_az The group name is group_a48-20
