DUA1640-5AAA02B-14 A PPENDIX B: M ANAGEMENT U SING Q UICK C ONFIG M ANAGERConnecting or Isolating Segments from Their Cascade SegmentsNext to each segment name button, is another button that shows ifthe segment is connected or isolated from its associated cascadesegment:n Green with a solid line through it — the segment is connected.n Blue with a broken line — the segment is isolated.Double-click the button to connect or disconnect the segment from thecascade segment.Displaying Information for the StackYou can display information for the stack by double-clicking on thezoom view:n If you double-click on a port, the Port Configuration dialog box isdisplayed. This is used to display and configure information about aport.n If you double-click on anything other than a port or button, theGeneral Info dialog box is displayed. This is used to display andconfigure information about the stack.ConfiguringSegmentsYou can use Quick Config Manager to set up the segments within thestack to create workgroups. For information on the segments and howthey work, refer to “Segments and Port Switching” on page 1-8.If you want to use load balancing to configure your segments, refer to“Load Balancing” on page B-18.Quick Config Manager handles segments at two levels: the segmentswithin each hub, and the cascade segments that run through the stack.Refer to “Connecting or Isolating Segments from Their CascadeSegments” on page B-14 for information on connecting and isolatingsegments from their associated cascade segments.By default, all ports are assigned to segment 1.Using the Segment Configuration panel, you can:n Move the ports between the segmentsn Name the segments
