1-8display mld ssm-mapping groupSyntaxdisplay mld ssm-mapping group [ ipv6-group-address | interface interface-type interface-number ][ verbose ]ViewAny viewDefault Level1: Monitor levelParametersipv6-group-address: Specifies a multicast group by its IPv6 address, in the range of FFxy::/16(excluding FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where x and y represent any hexadecimalnumber ranging from 0 to F.interface-type interface-number: Specifies an interface by its type and number.verbose: Displays the detailed multicast group information created based on the configured MLD SSMmappings.DescriptionUse the display mld ssm-mapping group command to view the multicast group information createdbased on the configured MLD SSM mappings.Note that:z If you do not specify an IPv6 multicast group, this command will display the information of all IPv6multicast groups created based on the configured MLD SSM mappings.z If you do not specify an interface, this command will display the multicast group information createdbased on the configured MLD SSM mappings on all interfaces.Examples# View the detailed information of IPv6 multicast group FF3E::101 created based on the configuredMLD SSM mappings on all interfaces. display mld ssm-mapping group ff3e::101 verboseInterface group report informationVlan-interface1(FE80::101):Total 1 MLD SSM-mapping Group reportedGroup: FF3E::101Uptime: 00:01:46Expires: offLast reporter: FE80::10Group mode: includeSource list(Total 1 source):Source: 30::1Uptime: 00:01:46Expires: 00:02:34Last-listener-query-counter: 0
