1-3 display mpls interface vlan-interface 2 verboseNo : 1Interface : Vlan2Status : DownTE Attribute : DisableLSPCount : 0CR-LSPCount : 0FRR : DisabledTable 1-2 display mpls interface command output descriptionField DescriptionTE Attr/TE Attribute Whether TE is enabled on the interfaceLSPCount Number of LSPs on the interfaceCR-LSPCount Number of CR-LSPs on the interfaceFRR Whether FRR is enabled on the interface. If FRR is enabled,the output will also include the bound tunnels.display mpls labelSyntaxdisplay mpls label { label-value1 [ to label-value2 ] | all }ViewAny viewDefault Level1: Monitor levelParameterslabel-value1: Specifies a label or, when used with the label-value2 argument, the start label of a range oflabels. The value of this argument ranges from 16 to 8191.to label-value2: Specifies the end label of a range of labels, in the range 16 to 8191.all: Specifies all labels.DescriptionUse the display mpls label command to display information about specified labels or all labels.Examples# Display information about labels in the range 900 to 1500. display mpls label 900 to 1500Label alloc state: '.' means not used, '$' means used------------------------------Static Label--------------------------------900:........ ........ ........ ........ ........ ........ ........ ........964:........ ........ ........ ........ ........ ........ ........ ....------------------------------Dynamic Label-------------------------------
