1-17address of the specified interface. If you want to display the source IP address in the log information,you can configure it by using this command.Note that:z The info-center loghost source command takes effect only after the information center isenabled with the info-center enable command.z The IP address of the specified source interface must be configured; otherwise, although theinfo-center loghost source command can be configured successfully, the log host will not receiveany log information.Examples# Configure interface VLAN-interface 1 as the egress interface to output log information to the log host. system-view[Sysname] info-center loghost source Vlan-interface 1info-center monitor channelSyntaxinfo-center monitor channel { channel-number | channel-name }undo info-center monitor channelViewSystem viewDefault Level2: System levelParameterschannel-number: Specifies a channel number, in the range 0 to 9.channel-name: Specifies a channel name, which could be a default name or a self-defined name. Theuser needs to specify a channel name first before using it as a self-defined channel name. For moreinformation, refer to the info-center channel name command.DescriptionUse the info-center monitor channel command to configure the channel to output system informationto the monitor.Use the undo info-center monitor channel command to restore the default channel to output systeminformation to the monitor.By default, output of system information to the monitor is enabled with a default channel name ofmonitor and a default channel number of 1.Note that the info-center monitor channel command takes effect only after the information center isenabled with the info-center enable command.Examples# Set to output system information to the monitor through channel 0. system-view
