Setting Up 3DM Preferenceswww.3ware.com 79To enable or disable remote access1 Click 3DM 2 Settings on the menu bar.2 In the Remote Access section of the 3DM 2 Settings page, select eitherEnabled or Disabled in the Allow Remote Connections field.The page refreshes, and a message at the top of the screen confirms thatremote access has been enabled or disabled.Setting the Incoming Port #You can set the port which 3DM uses to listen for incoming messages. If youare not sure which port would be the best to use, leave this set to the defaultport of 888.To set the incoming port1 Click 3DM 2 Settings on the menu bar.2 In the Incoming Port # section of the 3DM 2 Settings page, enter the portnumber in the Listening Port field.3 Click Change Port.The page refreshes, and a message at the top of the screen confirms thatthe listening port has been changed.Setting the Frequency of Page RefreshesSince the status of the drives attached to your 3ware RAID controller canchange while you are viewing information about them in 3DM, it is importantto refresh the page information regularly. That way you can be assured thatthe information you see in 3DM is current.You can manually refresh the information on a page by clicking RefreshPage in the menu bar. But you can also have 3DM refresh the information ona regular basis.To set the frequency of page refreshes1 Click 3DM 2 Settings on the menu bar.2 In the Page Refresh section of the 3DM 2 Settings page, select how oftenyou want the page to be refreshed in the Minutes Between Refresh field.Note: If you do not want 3DM to refresh the screen automatically,select Never in the Minutes Between Refresh field. You canthen refresh manually by clicking Refresh on your web browser.
