Actual signals and parameters 20514 RELAY OUTPUTS Status information indicated through relay output, and relayoperating delays.Note: Relay outputs 2…4 are available only if the MREL-01output relay module is connected to the drive. See MREL-01 output relay module user's manual (3AUA0000035974[English]).1401 RELAYOUTPUT 1Selects a drive status indicated through relay output RO 1.The relay energizes when the status meets the setting.FAULT(-1)NOT SEL Not used 0READY Ready to function: Run enable signal on, no fault, supplyvoltage within acceptable range and emergency stop signaloff.1RUN Running: Start signal on, Run enable signal on, no activefault.2FAULT(-1) Inverted fault. Relay is de-energized on a fault trip. 3FAULT Fault 4ALARM Alarm 5REVERSED Motor rotates in reverse direction. 6STARTED The drive has received start command. Relay is energizedeven if Run enable signal is off. Relay is de-energized whendrive receives a stop command or a fault occurs.7SUPRV1OVERStatus according to supervision parameters 3201…3203.See parameter group 32 SUPERVISION.8SUPRV1UNDERSee selection SUPRV1 OVER. 9SUPRV2OVERStatus according to supervision parameters 3204…3206.See parameter group 32 SUPERVISION.10SUPRV2UNDERSee selection SUPRV2 OVER. 11SUPRV3OVERStatus according to supervision parameters 3207…3209.See parameter group 32 SUPERVISION.12SUPRV3UNDERSee selection SUPRV3 OVER. 13AT SET POINT Output frequency is equal to the reference frequency. 14FAULT(RST) Fault. Automatic reset after the autoreset delay. Seeparameter group 31 AUTOMATIC RESET.15FLT/ALARM Fault or alarm 16EXT CTRL Drive is under external control. 17REF 2 SEL External reference REF 2 is in use. 18CONST FREQ A constant speed is in use. See parameter group 12CONSTANT SPEEDS.19All parametersNo. Name/Value Description Def/FbEq
