78 Control panels OperationYou operate the control panel with the help of menus and keys. You select an option,eg, operation mode or parameter, by scrolling the and arrow keys until theoption is visible in the display and then pressing the key.With the key, you return to the previous operation level without saving the madechanges.The basic control panel has five panel modes: Output mode, Reference mode,Parameter mode, Copy mode and Fault mode. The operation in the first four modesis described in this chapter. When a fault or alarm occurs, the panel goesautomatically to the Fault mode showing the fault or alarm code. You can reset thefault or alarm in the Output or Fault mode (see chapter Fault tracing on page 349).After the power is switched on, the panel is in theOutput mode, where you can start, stop, change thedirection, switch between local and remote control andmonitor up to three actual values (one at a time). To doother tasks, go first to the Main menu and select theappropriate mode.How to do common tasksThe table below lists common tasks, the mode in which you can perform them and the pagenumber where the steps to do the task are described in detail.Task Mode PageHow to find out the panel firmware version At power up 79How to switch between local and remote control Any 79How to start and stop the drive Any 79How to change the direction of the motor rotation Any 80How to browse the monitored signals Output 80How to set the speed, frequency or torque reference Reference 81How to change the value of a parameter Parameter 82How to select the monitored signals Parameter 83How to reset faults and alarms Output, Fault 349How to copy parameters from the drive to the control panel Copy 85How to restore parameters from the control panel to the drive Copy 85REM HzOUTPUT FWD491.REMMENU FWDPAr
