82 Control panels Parameter modeIn the Parameter mode, you can:• view and change parameter values• select and modify the signals shown in the Output mode• start, stop, change the direction and switch between local and remote control.How to select a parameter and change its valueStep Action Display1. Go to the Main menu by pressing if you are inthe Output mode, otherwise by pressingrepeatedly until you see MENU at the bottom.2. If the panel is not in the Parameter mode (“PAr” notvisible), press key or until you see “PAr”and then press . The display shows the numberof one of the parameter groups.3. Use keys and to find the desiredparameter group.4. Press . The display shows one of theparameters in the selected group.5. Use keys and to find the desiredparameter.6. Press and hold for about two seconds until thedisplay shows the value of the parameter withunderneath indicating that changing of the value isnow possible.Note: When is visible, pressing keys andsimultaneously changes the displayed value tothe default value of the parameter.7. Use keys and to select the parametervalue. When you have changed the parameter value,starts flashing.• To save the displayed parameter value, press.• To cancel the new value and keep the original,press .LOCMENU FWDrEFLOCMENU FWDPArLOCPAR FWD-01-LOCPAR FWD-11-LOCPAR FWD1101LOCPAR FWD1103SETSETLOCPAR SET FWD1SETLOCPAR SET FWD2LOCPAR FWD1103
