Parameters 30741.44 Set 2 sleep delay See parameter 40.44 Set 1 sleep delay. 60.0 s41.45 Set 2 sleep boosttimeSee parameter 40.45 Set 1 sleep boost time. 0.0 s41.46 Set 2 sleep booststepSee parameter 40.46 Set 1 sleep boost step. 0.041.47 Set 2 wake-updeviationSee parameter 40.47 Set 1 wake-up deviation. 0.00 rpm, %or Hz41.48 Set 2 wake-updelaySee parameter 40.48 Set 1 wake-up delay. 0.50 s41.49 Set 2 tracking mode See parameter 40.49 Set 1 tracking mode. Not selected41.50 Set 2 tracking refselectionSee parameter 40.50 Set 1 tracking ref selection. Not selected41.51 Set 2 trim mode See parameter 40.51 Set 1 trim mode. Off41.52 Set 2 trim selection See parameter 40.52 Set 1 trim selection. Torque41.53 Set 2 trimmed refpointerSee parameter 40.53 Set 1 trimmed ref pointer. Not selected41.54 Set 2 trim mix See parameter 40.54 Set 1 trim mix. 0.00041.55 Set 2 trim adjust See parameter 40.55 Set 1 trim adjust. 1.00041.56 Set 2 trim source See parameter 40.56 Set 1 trim source. PID ref41.60 Set 2 PID activationsourceSee parameter 40.60 Set 1 PID activation source. On4343 Brake chopper Settings for the internal brake chopper.43.01 Braking resistortemperatureDisplays the estimated temperature of the brake resistor, orhow close the brake resistor is to being too hot.The value is given in percent where 100% is the temperaturethe resistor would reach if the maximum continuous brakingpower (43.09 Brake resistor Pmax cont) is applied to theresistor for 100% rated time. The thermal time constant(43.08 Brake resistor thermal tc) defines the rated time toachieve 63% temperature. 100% would be reached when100% time has elapsed.This parameter is read-only.-0.0 … 120.0% Estimated brake resistor temperature. 1 = 1%43.06 Brake chopperfunctionEnables brake chopper control.Note: Before enabling brake chopper control, ensure that• a brake resistor is connected, and• the supply voltage range (parameter 95.01 Supply voltage)has been selected correctly.DisabledDisabled Brake chopper control disabled. 0Enabled withthermal modelBrake chopper control enabled with resistor overloadprotection.Note: Before using this setting, ensure that overvoltagecontrol is switched off (parameter 30.30 Overvoltage control).1Enabled withoutthermal modelBrake chopper control enabled without resistor overloadprotection. This setting can be used, for example, if theresistor is equipped with a thermal circuit breaker that is wiredto stop the drive if the resistor overheats.Before using this setting, ensure that overvoltage control isswitched off (parameter 30.30 Overvoltage control)2No. Name/Value Description Def/FbEq16
