Parameters and firmware blocks185Group 52 FBA DATA INThese parameters select the data to be sent by the drive to the fieldbus controller,and need to be set only if a fieldbus adapter module is installed. See also AppendixA – Fieldbus control on page 385.Notes:• This parameter group is presented in the User’s Manual of the fieldbus adapter asparameter group 3 or C.• The new settings will take effect when the drive is powered up the next time(before powering off the drive, wait at least 1 minute), or when parameter 51.27FBA PAR REFRESH is activated.• The maximum number of data words is protocol-dependent.5252 FBA DATA IN52.01 FBA DATA IN1 FW block: NoneSelects data to be transferred from the drive to the fieldbus controller.0 Not in use.4 Status Word (16 bits).5 Actual value 1 (16 bits).6 Actual value 2 (16 bits).14 Status Word (32 bits).15 Actual value 1 (32 bits).16 Actual value 2 (32 bits).101…9999 Parameter index.52.02 FBA DATA IN2 FW block: None… …52.12 FBA DATA IN12 FW block: NoneSee 52.01 FBA DATA IN1.
