Parameters and firmware blocks242Group 99 START-UP DATAStart-up settings such as language, motor data and motor control mode.The nominal motor values must be set before the drive is started; for detailedinstructions, see chapter Start-up on page 15.With DTC motor control mode, parameters 99.06…99.10 must be set; better controlaccuracy is achieved by also setting parameters 99.11 and 99.12.With scalar control, parameters 99.06…99.09 must be set.9999 START-UP DATA99.01 LANGUAGE FW block: NoneSelects the language.(0809h) ENGLISH English.(0407h) DEUTSCH German.(0410h) ITALIANO Italian.(040Ah) ESPAÑOL Spanish.(041Dh) SVENSKA Swedish.(041Fh) TÜRKÇE Turkish.99.04 MOTOR TYPE FW block: NoneSelects the motor type.Note: This parameter cannot be changed while the drive is running.(0) AM Asynchronous motor. Three phase AC voltage supplied inductionmotor with squirrel cage rotor.(1) PMSM Permanent magnet motor. Three phase AC voltage suppliedsynchronous motor with permanent magnet rotor and sinusoidalBackEMF voltage.
