Axis 27979R1 User Manual
                                                                                                                                                                 | |
Contents
|
The Test ButtonAXIS 5550 User’s Manual 129Section 13 The Test ButtonThe test button is located on the print server casing and is used for:• Printing a test page to check the connection to the printer.• Printing a server report and parameter list.• Performing a Factory Default of the print server.If you want to change any of the parameters, use one of the methodsdescribed in Section 10 Management and Configuration, on page 86.Printing a Test Page Press the test button once to print a test page. The test page containsbasic information about the AXIS 5550. It is recommended that you printa test page every time you connect the print server to a printer.Note:Printing the ServerReport & ParameterListPress the test button twice to print a server report and parameter listshowing the current AXIS 5550 settings.Server Report The Server Report includes the settings of the Axis Network Print Server,information about your connected printers as well as the current networksettings.Parameter List This list provides comprehensive details of all the parameters and theircurrent status. Refer to Section 16 The Parameter List, on page 137.Performing a FactoryDefault1. Remove the external power supply to switch off the print server.2. Press and hold down the test button while you reconnect the external powersupply.3. Continue to hold down the test button until the network indicator remainsconstantly lit. This should take about 20 seconds.4. Restart the print server by disconnecting and reconnecting the externalpower supply.Important:AXIS 5550 has two printer ports. If just one of ports is connected to a printer, the test page willbe printed on that port. If each port is connected to a printer, the default setting will send thetest page to the parallel printer. The default behavior can be changed from the print server’sinternal Web pages under Admin | General Settings => Change.A factory default will reset all print server parameters and settings to theirdefault values, except• installed certificate• private key |
Related manuals for Axis 27979R1
manualsdatabase
Your AI-powered manual search engine