Adding Printers in Windows30 AXIS 5550 User’s ManualAdding Printers in Windows 2000 / XP / 2003 using the Microsoft LPR MonitorThis section describes how to set up a Windows 2000/XP server for LPRprinting over the TCP/IP protocol, using the built-in Microsoft LPRMonitor i.e. Print Services for UNIX.Note:Basic Setup If you have not already done so, you should perform the TCP/IP basicsetup procedures prior to installing a printer for LPR printing.Preparing forLPR PrintingFollow the following steps to prepare for LPR printing:1. Open the Control Panel.2. Click Add/Remove Programs.3. Click Add/Remove Windows Components.4. Check Other Network File and Print Services and click Details.5. Check Print Services for Unix and click OK.6. Click Next and Finish.7. Close Add/Remove Programs and the Control Panel.Installing an LPRprinterFollow the instructions below to use the standard Windows method forinstalling an LPR printer in Windows 2000/XP:Windows XP/Server2003:1. Go to Start | Printers and Faxes and click the Add a Printer icon to startthe Add Printer Wizard. Click Next.Windows 2000: 1. Go to Start | Settings | Printers and click the Add Printer icon to startthe Add Printer Wizard. Click Next.2. Select the appropriate radio button: Local Printer. Click Next.3. Click the Create a new port radio button and select LPR Port from the list.Click Next.See “Alternative Method for LPR Printing” on page 31 for instructions onhow to set up printing over LPR without installing Print Services for Unix.