BEFORE EMBROIDERING102Embroidery Step by StepFollow the steps below to prepare the machine forembroidery.Attaching Embroidery Foot “W+” with LEDPointera Remove the presser foot and presser foot holder.(page 50)b Position the embroidery foot “W+” with LED pointeron the presser foot bar by aligning the notch of thepresser foot to the large screw.Side viewc Hold the embroidery foot in place with your righthand, and then use the disc-shaped screwdriver tosecurely tighten the presser foot holder screw.1 Presser foot holder screwBEFORE EMBROIDERINGStep # Aim Action Page1 Presser footattachmentAttach embroidery foot “W+”with LED pointer.1022 Checking theneedleUse needle 75/11 forembroidery.473 Embroidery unitattachmentAttach the embroidery unit. 1034 Bobbin threadsetupFor the bobbin thread, windembroidery bobbin thread andset it in place.365 Fabric preparation Attach a stabilizer material tothe fabric, and hoop it in theembroidery frame.1226 Pattern selection Turn the main power to ON,and select an embroiderypattern.1047 Embroidery frameattachmentAttach the embroidery frameto the embroidery unit.1258 Checking thelayoutCheck and adjust the size andposition of the embroidery.1269 Embroidery upperthread setupSet up embroidery upperthread according to thepattern.42Step 3Step 1, 2Step 7 Step 5Step 4Step 6, 8Step 9CAUTION• When attaching an embroidery foot, alwayspress on the screen. You mayaccidentally press the “Start/Stop” button andpossibly cause injury.• Be sure to use embroidery foot “W+” with LEDpointer when doing embroidery. Usinganother embroidery foot may cause the needleto strike the embroidery foot, causing theneedle to bend or break and possibly causeinjury.CAUTION• Use the disc-shaped screwdriver to firmlytighten the presser foot holder screw. If thescrew is loose, the needle may strike theembroidery foot and possibly cause injury.a