CARE AND MAINTENANCE172If the surface of the machine is dirty, lightly soak a clothin neutral detergent, squeeze it out firmly, and thenwipe the surface of the machine. After cleaning it oncewith a damp cloth, wipe it again with a dry cloth.If the screen is dirty, gently wipe it with a soft, dry cloth.Do not wipe the LCD screen with a damp cloth. Do notuse organic solvents or detergents.Restrictions on OilingIn order to prevent damaging this machine, it must notbe oiled by the user. This machine was manufacturedwith the necessary amount of oil applied to ensurecorrect operation, making periodic oiling unnecessary.If problems occur, such as difficulty turning thehandwheel or an unusual noise, immediately stop usingthe machine, and contact your authorized Baby Lockretailer.Precautions on Storing the MachineDo not store the machine in any of the locationsdescribed below, otherwise damage to the machinemay result, for example, rust caused by condensation.* Exposed to extremely high temperatures* Exposed to extremely low temperatures* Exposed to extreme temperature changes* Exposed to high humidity or steam* Near a flame, heater or air conditioner* Outdoors or exposed to direct sunlight* Exposed to extremely dusty or oily environmentsCleaning the Racea Press (Needle position button) to raise the needle.b Turn the main power to OFF.c Remove the needle, presser foot and presser footholder (page 47, page 50).d Remove the bobbin cover.e Slide the needle plate cover toward you to remove it.f Grasp the bobbin case, and then gently lift out.g Use the cleaning brush or a vacuum cleaner to removeany lint and dust from the race and bobbin threadsensor and the surrounding area.1 Cleaning brush2 Race3 Bobbin thread sensorh Insert the bobbin case so that the mark on thebobbin case aligns with the ● mark on the machine.* Align the and ● marks.1 mark2 ● mark3 Bobbin caseCARE AND MAINTENANCECAUTION• Be sure to unplug the machine before cleaningit. Otherwise, electric shock or injury mayresult.Note• In order to extend the life of this machine,periodically turn it on and use it. Storing thismachine for an extended period of time withoutusing it may reduce its efficiency.Note• If the flat bed attachment is attached, the needleplate can be removed when the accessorycompartment is opened.Note• Do not apply oil to the bobbin case.• If lint or dust collects on the bobbin thread sensor,the sensor may not operate correctly.abcaba bc