ADJUSTING THE SCREEN174e Lightly finger-tighten the screw on the right side of theneedle plate. Then, use the screwdriver included tofirmly tighten the screw on the left side. Finally, firmlytighten the screw on the right side.f Replace the bobbin case and the needle plate coverfollowing steps h through j in “Cleaning the Race”.Touch Panel is MalfunctioningIf the screen does not respond correctly when youtouch a key (the machine does not perform theoperation or performs a different operation), follow thesteps below to make the proper adjustments.a Holding your finger on the screen, turn the mainpower switch to OFF and back to ON. The touch panel adjustment screen appears.b Using the included touch pen, lightly touch the centerof each +, in order from 1 to 13.c Turn the main power to OFF, then turn it back to ON.Note• If the needle plate has been removed, checkmachine operations to confirm that installation hasbeen completed correctly. Refer to “CheckingMachine Operations” on page 177.ADJUSTING THE SCREENNote• Only use the included touch pen to touch thescreen. Do not use a mechanical pencil, pin, orother sharp object. Do not press too hard on thescreen. Otherwise, damage may result.Note• If you finish the screen adjustment and the screenstill does not respond, or if you cannot do theadjustment, contact your authorized Baby Lockretailer.