CONFIRMING THE PATTERN POSITION126■ Removing the Embroidery Framea Press (Presser foot lifter button) to raise thepresser foot.b Raise the frame-securing lever.c Pull the embroidery frame toward you.The pattern is normally positioned in the center of theembroidery frame. If the pattern needs to be repositionedfor better placement on the garment, you can check thelayout before starting embroidery.Checking the Needle Drop Point with theEmbroidery Foot “W+” with LED Pointera Press in the embroidery screen. The LED pointer indicates the needle drop point.■ Adjusting the LED PointerAdjust the LED pointer if it indicates a point different thanthe actual needle drop point. Before adjusting the LEDpointer, mark the actual needle drop point on the fabric tobe embroidered, and attach the embroidery frame.a Press . The settings screen appears.b Press . The embroidery settings screen appears.CONFIRMING THE PATTERNPOSITIONMemo• When the LED pointer turns on, the presser footheight is automatically adjusted according to thefabric thickness.• appears when the embroidery foot “W+” withLED pointer is attached to the machine.• If is not displayed, you cannot use the LEDpointer.• The LED pointer turns off automatically by loweringthe presser foot or returning to the previous page.Note• With spongy fabric, the position may not beaccurate due to the various depths of the fabric.• With fabric that has a very uneven surface such asquilting, the fabric thickness may not be correctlymeasured. In this case, the pointer indicationshould be used only as a reference.
