CONFIRMING THE PATTERN POSITION128■ Calibrating the Position of the BackgroundImageBy calibrating the position of the background imagetransferred to the machine, the pattern can be positionedmore accurately.a Select a pattern. (page 104)b Set the application to advanced mode, attach theembroidery positioning sticker to the fabric in thehoop, take the photo of the background, and with theadvanced mode of the application, transfer it to themachine.For a detailed procedure, refer to the application.c Press .* Attach the frame used in the image before pressing. The carriage will move, and the LED pointer will turnon.d Use to align the LED pointer with the centerof the larger circle in the embroidery positioningsticker.1 Center of the larger circle in the embroidery positioningstickere Press . The position of the background image is calibrated.■ Aligning the Embroidering Positiona Calibrate the position of the background image.(page 128)b Press .c When the following message appears, press .d Select the position to be set as the reference point.Memo• The position can also be calibrated by lowering theneedle with the handwheel. This method enablesmore accurate positioning. Slowly turn thehandwheel toward you (counterclockwise) to checkthe needle drop point. Then, turn the handwheelaway from you (clockwise) until the mark on thehandwheel is at the top. The carriage cannot moveif the mark on the handwheel is not at the top.11 MarkaMemo• The orientation of the pattern will changedepending on the orientation of the embroiderypositioning sticker.
