NAMES OF MACHINE PARTSGetting Ready191Using the Multi-Purpose ScrewdriverSince the screwdriver can be changed to three differentpositions, it can be extremely useful for the variousmachine preparations.Using the Spool StandThe included spool stand is useful when using threadspools with a large diameter (cross-wound thread). Thespool stand can hold two spools of thread.Free-motion quilting footBLG-FMCircular attachmentBL-CSAEdge Joining footESG-EJFOpen toe sole for dual feed footBLTY-OTDFStitch in the ditch sole for dual feed footBLDY-SDDF1/4" sole with guide for dual feed footBLDY-QFDFCouching footBLTY-CCFUSB mouseXE5334-101Part NamePart CodeMemo• To obtain optional accessories or parts, contactyour authorized Baby Lock retailer or visit our site“ www.babylock.com ”.• All specifications are correct at the time of printing.Please be aware that some specifications maychange without notice.• A variety of feet are available to enable differenttypes of stitching and finishes. Visit your nearestauthorized Baby Lock retailer or our site “www.babylock.com ” for a complete listing ofoptional accessories available for your machine.• Always use accessories recommended for thismachine.Position “1” You can install/remove the presser foot holder,needle clamp screw.Position “2” You can install/remove the needle plate.Position “3” The multi-purpose screwdriver can bepositioned over the screw on the embroideryframe to tighten the screw after hooping thefabric or when removing the fabric.1 2 34 5 67 8 9