Bang & Olufsen BeoVision Avant-55 User Manual

Also see for BeoVision Avant-55: Quick guide User guide

Contents

Bang & Olufsen BeoVision Avant-55 User Manual Manual pdf 12 page image

Set the maximum angle the television will turn on the motorised floor stand or wallbracket. Remember to leave enough space around the television to allow it to turn freely.If your television is mounted on the motorised table stand, it can be slightly tilted toavoid disturbing reflections. For more information, press the red button in the on-screenhelp and find 'Set a stand position'.If the television is to be moved when mounted on the floor stand, it must be moved byqualified personnel. Also, it is important that the stand is set in transport mode. Whenplaced in a new position, the stand must be calibrated again. Bring up Settings, thenStand to set it up again.OverviewLocate the connection panel and other important items:1. Holes for mounting of a wall bracket.2. Holes for mounting of a stand.3. Covers for the connection panel. Slide the covers to the sides to reveal theconnection panel.4. Standby indicator.Depending on your setup, different stand or wall bracket covers may be used. See theguide for your stand or wall bracket for information on how to mount such covers.Run cablesGather the cables from the upper and lower part of the panel, fasten them with cable tiesand run them upwards or downwards behind the cable holders depending on wallbracket or stand placement. See the illustrated example.When mounted on a motorised stand or wall bracket, make sure that there is enoughslack in the cables to allow the television to turn to either side or tilt before you fasten thecables with cable ties to make a neat bundle.12