Bang & Olufsen BeoVision Avant-55 User Manual

Also see for BeoVision Avant-55: Quick guide User guide

Contents

Bang & Olufsen BeoVision Avant-55 User Manual Manual pdf 55 page image

Example of recommended setup either wired or wireless. Here, you add a Bang & Olufsenrecommended router.Wired setupConnect one end of the Ethernet cable to the router and the other end to the Ethernetsocket  on the television.* You can then make the wired connection. It is assumed thatyou have enabled the DHCP service on your network.1. Make sure that the router is switched on.2. Press , highlight Settings and press the centre button.3. Highlight Wireless and Networks and press .4. Highlight Wired or wireless and press .5. Highlight Connect to network and press the centre button.6. Select Wired. The television constantly searches for the network connection.7. A message will be shown when the connection is successful.*Use a shielded Ethernet cable.Wireless setupIf your router has the WPS feature (wireless protected setup), you can make a wirelessconnection to your network directly. You can also search for a network. It is assumed thatyou have enabled the DHCP service on your network and that the SSID is not hidden.Wireless1. Press , highlight Settings and press the centre button.2. Highlight Wireless and Networks and press .3. Highlight Wired or wireless and press .4. Highlight Connect to network and press the centre button.5. Select Wireless.6. In the list of found networks, select your wireless network. If your network is notin the list because the network name is hidden (you switched off the SSIDbroadcast of the router), select Enter Name to enter the network name yourself.7. Depending on the type of router, enter your encryption key - WEP, WPA orWPA2. If you have entered the encryption key for this network previously, youcan use the centre button to accept and make the connection immediately.8. A message will be shown when the connection is successful.WPSIf your router has WPS, you can directly connect to the router without scanning fornetworks. If you have devices in your wireless network that use the WEP securityencryption system, you cannot use WPS.1. Press , highlight Settings and press the centre button.2. Highlight Wireless and Networks and press .3. Highlight Wired or wireless and press .4. Highlight Connect to network and press the centre button.5. Select WPS.6. Go to the router, press the WPS button and return to the television within twominutes.7. Select Connect to make the connection.8. A message will be shown when the connection is successful.WPS with pin codeIf your router has WPS with a pin code, you can directly connect to the router withoutscanning for networks. If you have devices in your wireless network that use the WEPsecurity encryption system, you cannot use WPS.55