Bang & Olufsen BeoVision Avant-55 User Manual

Also see for BeoVision Avant-55: Quick guide User guide

Contents

Bang & Olufsen BeoVision Avant-55 User Manual Manual pdf 24 page image

find 'Placement'.Depending on your setup, you can bring up a Stand adjustment menu for stand positionsor wall bracket positions.The calibration process allows you to set the maximum angle the television will turn – leftand right.Set up the television with a motorised floor stand1. In the Stand adjustment menu, use  and  to turn the television by the pipe ofthe floor stand and  and  to turn the television by the base of the floorstand. The television must be parallel to the wall behind.2. Press the centre button to proceed to the next step.3. Use ,  or the number buttons to enter the distance between the stand andthe wall.4. Highlight Save and press the centre button.If your television has just been moved, you will also be asked to set up new standpositions. Press the red button in the on-screen help and find 'Set a stand position' formore information.Set up the television with a motorised wall bracket1. In the Stand adjustment menu, press  or  to turn the television to thepreferred position when fully closed.2. Press the centre button to proceed to the next step.3. Press  or  to turn the television to the preferred position when fully opened.4. Press the centre button to save.Set up the television with a table standWhen mounted on a table stand, you can tilt the television to the position you prefer.1. In the Stand adjustment menu, press  or  to tilt the television to apreferred position.2. Press the centre button to save.Transport of a standMoving of your television and floor stand to a different location, must be done byqualified personnel. You must activate the transport mode. This ensures that thecalibration menu is shown when you switch on the television again, so you can determinethe distance to the wall again. All the saved stand positions are deleted when youactivate transport mode.WARNING! Do not lift or otherwise move your television physically when it is mountedon the floor stand. It could cause the TV screen to break. Contact your retailer.1. In the Stand transport menu, select Yes and press the centre button to activatetransport mode. To deactivate transport mode, select No instead.When the stand has been moved, you must calibrate the stand and set up standpositions again.24