14 144 Test Mode4.1 Test Mode without a Print JobFig. 7 DisplayBy alternating between buttons and on the display it is possible to simulate the labeling processwithout an active printing job. Push button .This causes the feed of an empty label. Simultaneously the vacuum of the pad as well as the supporting air areactivated. As soon as the label has securely arrived at the pad the supporting air is switched off. Push button .The cylinders are controlled so that the pliers move into the labeling position. The pliers are closed and formedon the product a label flag. After the transfer of the label, the cylinders are reversed, so that the pliers opens andmoves back to the normal positioni Note! Use the printer configuration to find the best peel-off offset for the initiation.4.2 Test Mode with a Print JobThis method allows testing of the labeling process with actual printing data by using the button. Send a print job.The test mode is executed in steps. Every step will start by using the button.A label is printed. The vacuum of the suction pads as well as the supporting air (blow tube) are switched on. After thelabel has been picked up by the pads, the supporting air is switched off. The pad assembly move into the labelingposition and will closed. The pliers are closed and formed on the product a label flag. Set it by the parameter Lock Time. After the transfer of the label, the cylinders are reversed, so that the pliers opens. By the parameter Cleaning blowit's possible to to close and opens the pliers again. The pad assembly moves back to the normal positionIf the label is manually removed from the pad after the first half cycle, the half cycle 1 will be repeated when thepre-dispense key is pressed again.i Note! Use the software to find the best peel-off offset for the initiation.