CAB 4712 Service Manual

Also see for 4712: Assembly instructions Operator's manual Service manual

Contents

CAB 4712 Service Manual Manual pdf 41 page image

417 Failure7.1 Error Messages of the PrinterFor detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)  Check the operator's manual of theprinter.Error treatment: Clearing the error results. Press the to synchronize the label feed, remove the left over labels manually.To quit the error state press Repeat .After error correction, the label causing the error will be reprinted.7.2 Error Messages of the ApplicatorThe following table contains an overview of applicator specific error messages and their possible causes. It alsosuggests methods to resolve the error states:Error Message Possible CauseAir pressure error Compressed air is switched offPressure to low < 4 barPressure to high > 6 barLabel not depos. Label has not been placed onto the product; after the pad has moved back the label stillsticks on the padUpper position not reached Pad is not in start position if the printer swiched onPad has not reached the home position within 2s after the movement of the pad was startedPad has undefined leaving the start positionExternal error Process of labeling was braked via the I/O interface of the printer with the XSTP signalUpper position not left There has been no change of the switch state at the upper sensor at the cylinderbetween the start of the labelling process and the signal from the labelling positionsensorVac. plate empty Label has not been picked up properly by the pad; or label fell off the pad before it couldbe placed onto the productLower position not reached Pad has not reached the starting position within 2s after the pad has left the labellingposition; or pad has left the starting position unauthorizedTable 4 Fehlermeldungen des ApplikatorsError treatment: Clear the error state. In order to clear the error state press continue, repeat or cancel.Continue with the next label in the printing queue.Repeat respectively the pause and enter key repeat the print of the label causing the error.Only applicable with error Vac. plate empty.Cancel the current print job.! Warning!After the error has been resolved the pad will immediately move back to the starting position!Danger of injury to hands and fingers by the moving pad! Do not reach into the area of the moving pad and keep long hair, loose clothes, and jewelry away.Reprinting a label, interrupted by an error, is not possible without a new printing job. In the mode "apply/print" before the standard cyclic operation can commence the signal "print first label" must besent or push respectively the enter key to send a printed label to the pad.