336.13 Setting of the End Position Dampeneri Note!The end position dampening of the lifting cylinders are set by default and will normally not need to beadjusted.21The end position dampening of the cylinder z is for relief ofmechanical strain particularly at higher speeds or when usinga larger mass.The end position dampening is best set up so the pistonreaches both ends securely but does not impact anythingharshly.By raising the end position dampeners the speed of the pistonis reduced and so the overall time cycle is increased. At cylinder (1) turn the setting screw (2) clockwise toincrease the end position dampening. At cylinder (1) turn the setting screw (2) counter-clockwiseto decrease the end position dampening..Fig. 35 End position dampening cylinder 'Z'6 Adjustments
